Code: SC386
Description: Amount of toner on sensor pattern too low during ID pattern measurement The amount of toner obtained during YCM ID pattern measurement was less than (target value for the amount of toner) minus (threshold value for detecting insufficient toner density) 5 consecutive times, even though there was no toner end condition - If ID sensor error (SC385) is detected before this SC, no detection is attempted unless Vsg is adjusted and the ID sensor error condition is reset. - This SC does not apply to black toner since the toner end sensor is not used for Bk.
Causes: Defective toner end sensor, dirt in toner cartridge end sensor window
Remedy: This SC is only logged in the memory (not displayed), so no particular action is required (no adverse influence is exerted on copier operation). Defective toner end sensor: SP5-803-010 (Input check: toner end sensor), replace if necessary. Dirty toner end sensor window: Clean. Toner supply seal peeled off: Remove the cartridge and check the seal in the hopper.