Code: SC524
Description: Duplex - End fence jogger H.P. error - Timing & Condition - • The home position is still detected a few seconds after the end fence leaves from the home position. • The home position is not detected 13 seconds after the end fence moves back to the home position.
Causes: • Duplex unit not set properly • Excessive load • Poor connection of connector • Defective end fence motor • Defective I/O control board
Remedy: 1. Pull out and re-insert the duplex unit. 2. Check the connector (CN486) is properly connected on the duplex control board. 3. Check if anything causes overload to the motor. 4. Replace the end fence motor (Output Check: SP 5-804 95 and 96). 5. Replace the I/O control board.