Code: SC361
Description: Revolver HP sensor error - Timing & Condition - The home position is not detected during 3 revolution of the revolver unit after the revolver motor turns on.
Causes: Poor connection of connector Dirty sensor Defective sensor Defective revolver motor Defective revolver drive board Defective I/O control board Defective main control board
Remedy: 1. Make sure the sensors are properly connected. 2. Replace the revolver H.P. sensor if the voltage at CN216-B5 on the I/O control board does not change when covering the sensor with a piece of paper. NOTE: Make sure that the revolver unit is locked in this step. 3. If the revolver unit does not rotate; 1) Replace the revolver motor. 2) Replace revolver motor drive board. 3) Replace the I/O control board. 4) Replace the main control board. [Signal Check] • Revolver H.P.: CN216-B5 or TP107 on the I/O control board