Code: SC452
Description: Belt mark detection error - Timing & Condition- The main control board does not receive the belt mark detection signal from the belt mark detection sensor.
Causes: • Dirty or damaged belt mark • Belt mark out of position • Defective sensor • Defective I/O control board • Defective main control board
Remedy: 1. Make sure the image transfer release lever is properly set. 2. Clean the belt mark. 3. Replace the transfer belt if the belt mark peels off or is damaged. 4. Clean the belt mark sensor. 5. Replace the belt mark detection sensor. 6. Replace the I/O control board. 7. Replace the main control board. [ Signal Check ] • Belt mark: CN220-A12, TP106, or CN212- B11 on the I/O control board / CN303-B1 or TP108 on the main control board.