Code: 6018
Description: Laser error
Causes: 1. When the polygon motor M_Lock signal becomes inactive for 0.4 seconds 8 seconds after the polygon motor (M6) starts driving until the polygon motor (M6) stops, the printer detects that the laser is abnormal. 2. When the LD_SOS signal is not detected for the specified time after the polygon motor is turned on and laser emission is started, the printer detects that the laser is abnormal. 3. When LD_SOS signal is not detected during the printing (during laser emission), the printer detects laser is abnormal.
Remedy: 1 Check the connector on the mechanical control board of the print head and polygon motor. - Remove the connector PJ27A and insert it again. Remove the connector PJ12A and insert it again. 2 - - Replace the print head unit. Replace the laser safety switch. Others Replace PWB-A.