Code: 101
Description: Fuser error
Remedy: 1 Initial setting Do the following checks show a problem? • Fuser Assy installation Reinstall applicable parts. Go to step 2. 2 Fuser Assy and Harness Assy FSR2 connector check 1. Remove the Fuser Assy. (Refer to Ch4-4.2.12.1) 2. Check if there are any broken or bent terminals in the Fuser Assy and Harness Assy FSR2. Are any of the terminals in the Fuser Assy and Harness Assy FSR2 connectors bent or broken? Go to step 3. Replace the applicable parts. 3 Fuser Assy 1. Replace the Fuser Assy. (Refer to Ch4-4.2.12.1) 2. Turn On the power. Does the error still occur? Go to step 4. End of procedure 4 Harness Assy FSR 2 continuity 1. Remove the Fuser Assy. (Refer to Ch4-4.2.12.1) 2. Disconnect the P/J138 relay connector between the Harness Assy Front 1 and the Harness Assy FSR2. 3. Disconnect the P/J162 connector from the LVPS . 4. Check the continuity for the following lines. J232-A2 <=> P138-4 J232-A1 <=> P138-5 J232-3 <=> J162-2 J232-1 <=> J162-1 Is there continuity in all lines? Go to step 5. Replace the Harness Assy FSR2 . 5 Harness Assy Front 1 continuity 1. Disconnect the P/J13 connector from the PWBA MCU & HVPS . 2. Check the continuity6 Harness Assy LVNC continuity 1. Disconnect the P/J61 connector from the PWB Drive . 2. Disconnect the P/J165 connector from the LVPS . 3. Check the continuity between J61-4 <=> J165-5. Is there continuity between J61-4 <=> J165-5? Go to step 7. Replace the Harness Assy LVNC . 7 Harness Assy DRV 2 continuity 1. Disconnect the P/J12 connector from the PWBA MCU & HVPS. (Refer to Ch4-4.2.18.1) 2. Disconnect the P/J42 connector from the PWB Drive . 3. Check the continuity between J12-20 <=> J42-11. Is there continuity between J12-20 <=> J42-11? Go to step 8. Replace the Harness Assy DRV 2 . 8 PWB Drive continuity Check the continuity between P42-11 <=> P61-4 of the PWB Drive. Is there continuity between P42-11 <=> P61-4? Go to step 9. Replace the PWB Drive. (Refer to Ch4-4.2.18.5) 9 LVPS 1. Replace the LVPS with a new part. (Refer to Ch4-4.2.18.3) 2. Turn On the power. Does the problem still occur? Replace the PWBA MCU & HVPS. (Refer to Ch4-4.2.18.1) Problem solved. for the following lines. J138-5 <=> J13-17 J138-4 <=> J13-18 Is there continuity in all lines? Go to step 6. Replace the Harness Assy Front 1 .