Code: 100
Description: - Laser power has weakened.
- SOS signal cannot be detected
- SOS signal cannot be detected
Remedy: 1 Connection Check of the HARNESS ASSY ROS Disconnect and reconnect the HARNESS ASSY ROS connector. Does the error recur even when the power is turned off and back on again? Go to Step [2]. End of procedure 2 Continuity Check of the HARNESS ASSY ROS 1. Disconnect P/J151 connector of the ROS ASSY, and P/J15 connector on the PWBA MCU IDTN. 2. Check the continuity of J15<=>J151. Is there normal continuity between them? Go to Step [3]. Replace the HARNESS ASSY ROS. 3 Check of the ROS ASSY Replace the ROS ASSY. Does the error still occur after the replacement? Replace the PWBA MCU IDTN. End of procedure