Code: 101
Description: - The printer detected that the Temp Sensor is broken.
- Abnormal high temperature was detected (approx. 250 degrees C or more).
- Abnormal low temperature was detected during printing (approx. 100 degrees or lower).
- Abnormal temperature difference was detected between the center and the end of the Fuser Roll.
- The printer detected that the circuit for the Fuser Roll center sensor is in failure.
- The printer detected that the Fuser Roll center sensor is abnormal.
- Abnormal warm-up time was detected. (Ready waiting time exceeded 60 seconds.)
- Abnormal low temperature was detected (approx. 180 seconds or more).
- Abnormal Temp sensor warm-up time was detected (approx. 30 minutes or more at 0 degree C or less).
- Abnormal high temperature was detected (approx. 250 degrees C or more).
- Abnormal low temperature was detected during printing (approx. 100 degrees or lower).
- Abnormal temperature difference was detected between the center and the end of the Fuser Roll.
- The printer detected that the circuit for the Fuser Roll center sensor is in failure.
- The printer detected that the Fuser Roll center sensor is abnormal.
- Abnormal warm-up time was detected. (Ready waiting time exceeded 60 seconds.)
- Abnormal low temperature was detected (approx. 180 seconds or more).
- Abnormal Temp sensor warm-up time was detected (approx. 30 minutes or more at 0 degree C or less).
Remedy: 1 Initial Check Are the parts listed below installed incorrectly? Fuser unit Do not turn the printer On and Off with the Fuser unit removed. Otherwise you may get an electric shock. Reinstall the part(s) correctly. Go to Step [2]. 2 Check of the Fuser unit connector Disconnect the Fuser unit. Are the connector pins bent or broken? Go to Step [3]. Replace the defective part. 3 Check of the Fuser unit Replace the Fuser unit with a new one. Does the error still occur after the replacement? Go to Step [4]. End of procedure 4 Check of the LVPS Replace the LVPS with a new one. Does the error still occur after the replacement? Replace the PWBA MCU IDTN. End of procedure