Code: 105
Description: Motor failure (Main Drive Motor/Deve Motor/Fuser Motor)
Remedy: 1 Initial Check Check for the following items. Is there anything wrong among them? • Installation state of the DRIVE ASSY MAIN, and wear or damage of the gears. • Installation state of the DRIVE ASSY FUSER, and wear or damage of the gears. • Installation state of the DRIVE ASSY DEVE, and wear or damage of the gears. • Wear or damage of the rollers or gears in the unit. • Foreign material in the unit. Replace the defective part(s). Go to Step [2] when some troubles are found in the DRIVE ASSY MAIN. Go to Step [6] when some troubles are found in the DRIVE ASSY FUSER. Go to Step [10] when some troubles are found in the DRIVE ASSY DEVE. 2 Check of the Main Drive Motor Does the rotor rotate smoothly when turning it with your hand? Go to Step [3]. Reinstall the part(s) correctly. 3 Continuity Check of the HARNESS ASSY FAN/PHD/MOT 1. Disconnect P/J481 connector of the DRIVE ASSY MAIN, and P/J48 connector on the PWBA MCU IDTN. 2. Check the continuity of J481<=>J48. Is there normal continuity between them? Go to Step [4]. Replace the HARNESS ASSY FAN/ PHD/MOT. 4 Check the Main Drive Motor Replace the DRIVE ASSY MAIN with a new one. Does the error still occur after the replacement? Go to Step [5]. End of procedure 5 Check of the Interlock Switch Is the Interlock Switch pressed down normally? Go to FIP-DC Reinstall the part(s) correctly. 6 Check of the Fuser Motor Does the rotor rotate smoothly when turning it with your hand? Go to Step [7]. Reinstall the part(s) correctly. 7 Continuity Check of the HARNESS ASSY TNRFULL/FSR 1. Disconnect P/J521 connector of the DRIVE ASSY FUSER, and P/J52 connector on the PWBA MCU IDTN. 2. Check the continuity of J521<=>J52. Is there normal continuity between them? Go to Step [8]. Replace the HARNESS ASSY TNRFULL/FSR. 8 Check of the Fuser Motor Replace the DRIVE ASSY FUSER with a new one. Does the error still occur after the replacement? Go to Step [9]. End of procedure 9 Check of the Interlock Switch Is the Interlock Switch pressed down normally? Go to FIP-DC Reinstall the part(s) correctly. 10 Check of the Deve Motor Does the rotor rotate smoothly when turning it with your hand? Go to Step [11]. Reinstall the part(s) correctly. 11 Continuity Check of the HARNESS ASSY FAN/PHD/MOT 1. Disconnect P/J491 connector of the DRIVE ASSY DEVE, and P/J48 connector on the PWBA MCU IDTN. 2. Check the continuity of J491<=>J48. Is there normal continuity between them? Go to Step [12]. Replace the HARNESS ASSY FAN/ PHD/MOT. 12 Check of the Deve Motor Replace the DRIVE ASSY DEVE with a new one. Does the error still occur after the replacement? Go to Step [13]. End of procedure 13 Check of the Interlock Switch Is the Interlock Switch pressed down normally? Go to FIP-DC Reinstall the part(s) correctly.