Code: 107
Description: - Temperature of 100 degrees or more, or 20 degrees or less was detected.
- Humidity of 100 % or more was detected.
- Humidity of 100 % or more was detected.
Remedy: 1 Initial Check Is the part below installed incorrectly? • SENSOR HUM Reinstall the part(s) correctly. Go to Step [2]. 2 Continuity Check of the HARNESS ASSY TMP 1. Disconnect P/J231 connector of the SENSOR HUM, and P/J24 connector on the PWBA MCU IDTN. 2. Check the continuity of J231<=>J24. Is there normal continuity between them? Go to Step [3]. Replace the HARNESS ASSY TMP. 3 Check of the SENSOR HUM. Replace the SENSOR HUM with a new one. Does the error still occur after the replacement? Replace the PWBA MCU IDTN. End of procedure