Code: 113
Description: Fuser Unit malfunction (No Fuser Unit)
Remedy: 1 • Initial checking: Is there any parts of wrong specifications used, improper mounting, damage, distortion, dirt, or adherence of foreign matter? • Major parts to be checked: FUSER ASSY, MCU PWB, FUSER HARNESS ASSY, FUSER CONNECTOR Replace or reinstall the relevant part. Go to step 2 2 • Checking whether the problem lies in engine or controller: Can a test print (single sheet / consecutive printing, about 10 sheets each) be performed normally with the engine alone? Check the Printer Controller. (If an error still occurs after replacing, go to step 3.)] Go to step 3 3 • Checking for proper mounting of FUSER ASSY: Is the FUSER ASSY properly mounted? • Check by removing and reinstalling the FUSER ASSY. • With the tool: Go to step 4 • Without the tool: Go to step 5 Replace the faulty part(s). 4 • Checking the FUSER ASSY detection circuit: Is the FUSER ASSY detection circuit functioning properly? . By using the diagnostics commander, check by Digital Input Test device code "4B". Go to step 5 Replace the MCU PWB-XL 5 • Checking the power supply to FUSER ASSY detection circuit: Is the voltage 5 VDC between P19B-5PIN . P19B-6PIN? Go to step 6 Replace the MCU PWB-XL 6 • Checking the FUSER ASSY detection signal Is the voltage between P/J19A-8PIN . P/J19A- 7PIN 0 VDC with the FUSER ASSY installed and 5 VDC without FUSER ASSY? Replace the MCU PWB-XL Go to step 7 7 • Checking for continuity of FUSER HARNESS ASSY Is there normal continuity between J71A . J78? Go to step 8 Replace the FUSER HARNESS ASSY 8 • Checking continuity of FUSER CONNECTOR Is there normal continuity between P71 . J19? Go to step 9 Replace the FUSER CONNECTOR 9 • Replacing the FUSER ASSY and Performing Checks Replace the FUSER ASSY. Is the problem solved? Problem solved Replace the MCU PWB-XL