Code: 534
Description: Fuser Unit malfunction (Low Temperature)
Remedy: 1 • Initial checking: Is there any parts of wrong specifications used, improper mounting, damage, distortion, dirt, or adherence of foreign matter? • Major parts to be checked: FUSER ASSY, MCU PWB, FUSER HARNESS ASSY FUSER CONNECTOR, FUSER ASSY, TEMP. SENSOR ASSY H/R HEATER, P/R HEATER, LV/HV POWER SUPPLY, MCU PWB Replace or reinstall the relevant part. Go to step 2 2 • Checking whether the problem lies in engine or controller: Can a test print (single sheet / consecutive printing, about 10 sheets each) be performed normally with the engine alone? Check the Printer Controller. (If an error still occurs after replacing, go to step 3.)] Go to step 3 3 • Checking the TEMP. SENSOR ASSY: Does the error occur immediately when the power is turned ON? Go to FIP-2.25 “Faulty TEMP. SENSOR ASSY” Go to step 4 4 • Checking the H/R HEATER and P/R HEATER: Do the H/R HEATER and P/R HEATER light when the FUSER ASSY is cold and the power is turned ON? Go to step 5 Replace the H/R HEATER , P/R HEATER 5 • Does the problem occur during the FUSER warm up? Go to FIP-2.25 “Faulty TEMP. SENSOR ASSY” Go to step 6 6 • Checking the MAIN HARNESS ASSY: Is there normal continuity between J21 . J32? Go to step 7 Replace the MAIN HARNESS ASSY 7 • Checking the LV/HV POWER SUPPLY: Is the voltage 5V DC between P21-1PIN . P21-2PIN? Go to step 8 Go to FIP-2.32 “Faulty LV/HV POWER SUPPLY” 8 • Checking the ON signal of HEATER ROD: Is the voltage between P/J33-1PIN . P/J12- 9PIN 0 VDC during the FUSER warm-up and 5 VDC when the warm-up is completed? Go to FIP-2.32 “Faulty LV/HV POWER SUPPLY” Replace the MCU PWB-XL