Code: 511
Description: Motor 1 malfunction
Remedy: 1 • Initial checking: Is there any parts of wrong specifications used, improper mounting, damage, distortion, dirt, or adherence of foreign matter? • Major parts to be checked: P/R MOT&DRV ASSY, TRANSFER HIGH ASSY TR0 SENSOR, MCU PWB Replace or reinstall the relevant part. Go to step 2 2 • Checking whether the problem lies in engine or controller: Can a test print (single sheet / consecutive printing, about 10 sheets each) be performed normally with the engine alone? Check the Printer Controller. (If an error still occurs after replacing, go to step 3.)] Go to step 3 3 • Checking the Process Motor operation: When the test print is conducted, does the Process Motor operate? Go to step 9 Go to step 4 4 • Checking the P/R MOT&DRV ASSY for foreign matters: Is the operation of the PROCESS DRIVE ASSY blocked by foreign matters? Remove the foreign matters. • With the tool: Go to step 5 • Without the tool: Go to step 6 5 • Checking the P/R MOT&DRV ASSY Does the P/R MOT&DRV ASSY function properly? . By using the diagnostics commander, check by Digital Output Test device code "72". Replace the MCU PWB-XL Go to FIP-2.28 “Faulty P/R MOT & DRV ASSY” 6 • Checking the installation of P/R MOT&DRV ASSY: Has the P/R MOT&DRV ASSY been installed properly? Go to step 7 Reinstall the P/R MOT & DRV ASSY 7 • Checking the installation of TRANSFER HIGH ASSY: Has the TRANSFER HIGH ASSY been installed properly? Go to step 8 Reinstall the TRANSFER HIGH ASSY 8 • Checking the P/R MOT&DRV ASSY Does the output shaft of the P/R MOT&DRV ASSY turn smoothly when the rotor of the P/R MOT&DRV ASSY is turned by hand? Go to step 9 Replace the P/R MOT & DRV ASSY 9 • Checking the installation of TR0 SENSOR: Has the TR0 SENSOR been installed properly? • With the tool: Go to step 8 • Without the tool: Go to FIP-2.21 “Faulty TR0 SENSOR” Reinstall the TR0 SENSOR 10 • Checking the TR0 SENSOR Does the TR0 SENSOR function properly? . By using the diagnostics commander, check by Digital Input Test device code "42". Replace the MCU PWB-XL Go to FIP-2.21 “Faulty TR0 SENSOR”