Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E053 — Epson AcuLaser C9100

Code: E053

Description: Development Unit error
- When Deve is brought into contact or separated, ON/OFF of the SENSOR ASSY TRACKING could not be confirmed within 2 sec after the MOTOR ASSY TRACKING was started.
Causes: • MOTOR ASSY TRACKING • SENSOR ASSY TRACKING • HARNESS ASSY DISP • MCU PWB
Remedy: 1 Check of MOTOR ASSY TRACKING 1. Remove the COVER ASSY REAR. 2. Turn the main power on. 3. During warming-up operation of the printer, check the rotation of the blocking plate of the SHAFT ASSY TRACKING from the SENSOR ASSY TRACKING mounting section. Can you confirm that the SHAFT ASSY TRACKING turns? To Step 3 To Step 2 2 Continuity check of HARNESS ASSY DISP 1. Disconnect the P/J22 of the MCU PWB. 2. Disconnect the J222 of the MOTOR ASSY TRACKING. 3. Check if the following wiring have continuity. J22-4 . J222-1 J22-5 . J222-2 Do all of the wiring have continuity? Replace the MOTOR ASSY TRACKING Replace the HARNESS ASSY DISP 3 Continuity check of HARNESS ASSY P-SIZE 1. Disconnect the P/J29 of the MCU PWB. 2. Disconnect the J291 of the SENSOR ASSY TRACKING. 3. Check if the following wiring have continuity. J29-1 . J291-3 J29-2 . J291-2 J29-3 . J291-1 Do all of the wiring have continuity? To Step 4 Replace the HARNESS ASSY PSIZE 4 Check of SENSOR ASSY TRACKING 1. Replace the SENSOR ASSY TRACKING. 2. Turn the main power on. Does the error occur? Replace the MCU PWB Problem solved

← Xem tất cả mã lỗi Epson AcuLaser C9100

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie