Code: 00010005
Description: CR Motor out of step
During CR Motor operation, there may be a case where the encoder pulse signal within the specified range is not input within a specified period of time or the pulse width is extremely long or short. In such a case, the CR Motor is judged to be out-of-step, so that this message is displayed and the printer stops operating.
During CR Motor operation, there may be a case where the encoder pulse signal within the specified range is not input within a specified period of time or the pulse width is extremely long or short. In such a case, the CR Motor is judged to be out-of-step, so that this message is displayed and the printer stops operating.
Causes: • Defective CR Motor. • CR Motor driver damage (42V system short) • Broken temperature fuse for Cutter Solenoid.
Remedy: 1. Check to see if the CR Scale for detection of the encoder pulse is removed 2. Check for dirt, paper dust or damage to the CR Scale. 3. Perform the CR Timing Belt Tension Adjustment 4. Replace the CR Encoder Sensor 5. Replace the CR_HP Sensor 6. Replace the Motor Assy., CR 7. Replace the C593 MAIN Board 8. Replace the Cutter Solenoid.