Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 0001000C — Epson Stylus Pro 4400

Code: 0001000C

Description: PG axis detection error
During initial operation at power on or during platen gap fluctuation (change) operation after paper setting, there may be a case where the PG home position can not be detected. In such a case, this message is displayed and the printer stops operating.
Causes: • Disconnected connector for the PG Phase Sensor. • Disconnected connector for the PG Motor. • Broken wire for the PG Motor. • Defective PG Phase Sensor. • Defective PG Motor. • Damage to wheel linkage of PG drive gears • Power supply fuse for PG/PO Motor driver is broken on the MAIN Board.
Remedy: 1. Connect PG Phase Sensor or PG Motor connector correctly. 2. Replace the PG Phase Sensor 3. Replace the Motor Assy., PG 4. Replace the C593 MAIN Board

← Xem tất cả mã lỗi Epson Stylus Pro 4400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie