Code: 50.2
Display: 50.X FUSER ERROR
Description: A fuser error has occurred.
fuser warmup service
fuser warmup service
Remedy: Fuser Failure (Abnormal Warmup) 1. The connector between the fuser and the printer is not connected properly. Reseat the fuser. Check the connector J5013 between the fuser and the printer. Replace it if damaged. 2. Break in the main thermistor. Turn the printer off and remove the fuser. Measure the resistance between the fuser connectors J5013LA-2 (MAINTH) and J5013LA-1 (GND). If it is not within the rage of 330k ohms to 50k ohms (at ambient temperature), replace the fuser. 3. Break in the fuser heater. Measure the resistance between the fuser connectors J5013L-2 (FSRH) and J5013L-1 (FSRN) with the fuser removed. If it is not within the rage of 12 ohms to 52 ohms (at ambient temperature), replace the fuser film unit. 4. Faulty DC controller. PCB Replace the DC controller PCB