Code: 57.2
Display: 57.2 FAN FAILURE
Description: The printer detected that the fan (an exhaust fan located in the upper, right rear corner of the printer, refer to Figure 7-34) was not rotating. This fan, operates off +24Vdc and is enabled by the DC controller PCB’s micro-processor.
Remedy: 1. Turn the printer off and on to reset the printer. Visually check to see if the fan is rotating (if you cannot see any rotation, place your hand over the outlet vents to see if exhaust air is moving). 2. Remove the printer’s left-side cover. Check to see if anything is preventing the fan from rotating freely. 3. Verify that the fan’s connector is firmly seated into connector J208 of the developing PCB. 4. If the error persists, replace fan.