Code: 13.JJ.NT
Display: 13.JJ.NT JAM IN OUTPUT BIN
Description: Paper is jammed in the output bin. Use this list to determine the exact location of the jam: • 13.12.07 = staple cartridge • 13.12.08 = output bin paper-present sensor (paper is stuck) • 13.12.09 = output bin inlet sensor (paper is stuck) • 13.12.10 = output bin inlet sensor (paper did not reach the sensor at the appropriate time) • 13.12.11 = paper present in the output bin when the MFP is turned on • 13.31.00 = paper jammed in the reversing assembly
Remedy: 1. Clear all jammed paper. 2. Verify that the connector J50 on the DC controller PCB is firmly seated. 3. Verify that the two connectors on the rear of the reversing assembly are installed. 4. Use the component diagnostics test to test three motors: switchback motor, intermediate switchback motor, and output motor. 5. Use the component diagnostics test to test two sensors: face-up/face-down solenoid and alienation solenoid. 6. Use the manual sensor test to test two sensors: paper delivery sensor and reversing-paper sensor. 7. If any of these components fail, replace the reversing assembly.