Code: 49.XX.XX
Display: 49.XX.XX PRINTER ERROR
Description: A critical firmware error has occurred that caused the processor on the formatter to abort operation. This type of error can be caused by invalid print commands, corrupt data, or invalid operations. In some cases, electrical noise in the cable can corrupt data during transmission to the printer. Other causes include poor-quality parallel cables, poor connections, or homegrown programs. On rare occasions, the formatter is at fault, which is usually indicated by a 79 Service Error.
Remedy: 1. Turn the MFP off then on. 2. Press Stop to clear the print job from memory. 3. Turn the MFP off then on. 4. Try printing a job from a different software program. If the job prints, go back to the first program and try printing a different file. If the message appears only with a certain software program or print job, contact the software vendor for assistance. 5. If the message persists with different software programs and print jobs, disconnect all of the cables to the MFP that connect it to the network or computer. 6. Turn the MFP off. 7. Remove all memory DIMMs or thirdparty DIMMs from the MFP. (Do not remove the firmware DIMM.) 8. Remove all EIO devices from the MFP. 9. Turn the MFP on. 10. If the error no longer exists, reinstall each DIMM and EIO device one at a time, making sure to turn the MFP off and on again as you install each device. 11. Replace a DIMM or EIO device if you determine that it causes the error. 12. Remember to reconnect all of the cables that connect the MFP to the network or computer. 13. If the error persists, upgrade the firmware before replacing the DC controller. 14. Replace the formatter and calibrate the MFP