Code: 13.12.10
Display: 13.12.10 Jam In Left Accessory
Description: Delay jam in entry. Paper did not arrive at the paper-inlet sensor PS1301 within the expected time. This signal is generated from sensor PS1301 (paper-inlet sensor). PS1301 is located under the lower entrance guide plate with the sensor arm extending up through the guide plate and into the paper path.
Remedy: 1. Remove the paper jam. 2. Open a new ream of paper and replace the paper in the paper tray. Try running the job again. If jamming stops, the problem is most likely excessive paper curl leaving the fuser. This is caused by damp paper from high humidity or poor-quality paper. 3. If the error persists with the new ream of paper, replace the stapler/stacker unit.