Code: 49.XXXXX
Display: 49.XXXXX ERROR
Description: A critical firmware error has occurred that caused the processor on the formatter to abort operation. This type of error can be caused by invalid print commands, corrupt data, or invalid operations. In some cases, electrical noise in the cable can corrupt data during transmission to the printer. Other causes include poor-quality parallel cables, poor-connections, or home-grown programs. On rare occasions, the formatter is at fault.
Remedy: 1. Turn the MFP off and then on. 2. Press Stop to clear the print job from the printer memory. 3. Turn the MFP off and then on. 4. Try printing a job from a different software program. If the job prints, go back to the first program and try printing a different file. If the message appears only with a certain software program or print job, contact the software vendor for assistance. 5. If the message persists with different software programs and print jobs, disconnect all of the cables to the printer that connect it to the network or computer. 6. Turn the MFP off. 7. Remove all memory DIMMs or thirdparty DIMMs from the printer. (Do not remove the firmware Compact Flash.) 8. Ensure that the formatter is securely seated. 9. Remove all EIO devices from the printer. 10. Turn the MFP on. 11. If the error no longer exists, install each DIMM and EIO device one at a time, making sure to turn the printer off and on again as you install each device. 12. Replace a DIMM or EIO device if you determine that it causes the error. 13. Remember to reconnect all of the cables that connect the printer to the network or computer. 14. Upgrade formatter and DC controller firmware, which can be found in a single . 15. If the error persists, upgrade the firmware compact flash card. 16. Replace the formatter and calibrate the printer. NOTE: Formatter failures producing 49 errors are extremely rare. Formatter replacement is probably not required.