Code: 66.12.22
Display: 66.12.22
Description: Finisher upper stapler-shift motor failure (M35) Error occurs when the stapler does not leave the stapler-shift home-position sensor (PI40) after the stapler-shift motor (M35) has driven for 5 seconds. Also occurs when the stapler fails to return to the stapler-shift home-position sensor (PI40) after the stapler-shift motor (M35) has been driven for 20 seconds.
Remedy: Control-panel diagnostics: M35-Staple Motor (Stapler-Shift Motor) and PI140-Stapler Home Sensor (Stapler Home Position Sensor) 1. Test the upper stapler-shift motor M35 by using the finisher component test from the control-panel display. • If the stapler unit moves properly, proceed to the next step in this section. • If the stapler unit does not move properly or moves erratically, perform the following steps: • Check the flat-flexible cable (FFC) for damage (dents, folds, and/or tears). Replace the FFC if necessary. • Check the FFC connectors and cable mounting areas. • If the error persists, replace the stapler assembly 2. Test the stapler-shift home-position sensor PI40 by using the finisher component test from the control-panel display. • If the sensor does not change state when the stapler unit is moved from the home position, perform the following steps: • Make sure that the sensor is securely fastened to the chassis. • Carefully clean the sensor body by gently blowing clean air across the sensor to remove dust and debris. • Verify that connector J1040 on the stacker controller PCA is fully seated and not damaged. Check the wiring at the sensor. • If the error persists, replace the stapler assembly. NOTE: The stapler assembly includes the stapler-shift home position sensor PI40, stapler unit, shift-position-plate assembly, and the flat-flexible cable (FFC).