Code: 13.12.46
Display: 13.12.46
Description: Finisher jam - door was opened during booklet making operation. Occurs while the machine is booklet making and the booklet-delivery-door sensor (PI3) or the booklet-paper-path open/close sensor (PI3) detects that the door or paper path has been opened. Also occurs when the finisher's front-door sensor (PI32) has been opened with paper remaining in the processing tray of the main stapler while the finisher is not operating.
Remedy: Control-panel diagnostics: PI31 (top-door sensor), PI32 (front-door sensor), PI3 (booklet-door-1 sensor) (booklet delivery door) To locate sensor PI31 and sensor PI32. 1. Test sensor PI31, sensor PI32, and sensor PI9 by using the finisher component test from the control-panel display. 2. Make sure that the front door, top door, and booklet-delivery door properly open and close and stay in the fully closed position. If the front door is not closing tightly at the top, it will not activate the door switch. If necessary, adjust the alignment of the front door by opening the door and carefully twisting it into proper alignment. 3. Verify that the sensor-activation arms on the doors are not damaged. 4. Make sure that the sensors and frontdoor switch MSW31 are not obstructed. 5. Make sure that the arm on switch MSW31 is not bent or damaged. 6. Make sure that sensors PI31, PI32, PI9, and switch MSW31 are securely fastened to the chassis. 7. Only if the error persists and none of the previous steps correct the problem, replace the stacker controller PCA.