Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 66.12.32 — HP Color LaserJet CM6049 MFP

Code: 66.12.32

Display: 66.12.32
Description: Finisher error: second-tray lift/lower motor (M38) Occurs when the output-bin 2 does not activate the home-position sensor (PI48) when the output-bin-1 shift motor (M38) is driven for 20 seconds. Also occurs when output-bin 2 does not move when output-bin-1–shift motor (M38) is driven for 4 seconds. Also occurs when bin-2 upper limit is detected by PS983, PS982, PS981 on the Tray-2-shift PCA when no paper has been sensed by the output-bin-2 paper sensor (PI43). NOTE: output-bin-2 home position is detected using the top sheet of paper on the bin when paper is present and the edge of the bin itself when there is no paper on the bin.
Remedy: Control-panel diagnostics: M38 (output-bin-2 motor) and PI48 output-bin-2 paper-surface sensor 1. Manually release output-bin 2, and position it at the mid point of its travel area. Test the output-bin-2-shift motor M38 by using the finisher component test from the control-panel display. • If output bin 2 moves during the test, perform the following steps. • Verify that the paper-surface sensor flag is not damaged, moves freely, and is correctly aligned with the PI48 sensor body. Also verify that when the top edge of the output bin engages the sensor arm that the sensor flag moves into sensor PI41. • Make sure that the sensor is securely fastened to the chassis. • Carefully clean by gently blowing clean air across the sensor to remove dust and debris. • Verify that intermediate connector J1040 and J721 on the stacker controller PCA are fully seated and not damaged. Check the wiring at the sensor. • If the error persist, replace sensor PI48. • If the error persist, replace the output-bin-2 assembly. NOTE: The output-bin-2 assembly includes the output-bin-2-shift motor (M38), output-bin-2 area sensors, and the output-bin-2 driver PCA. 2. If output bin 2 does not move during the test, perform the following steps. • Check the output-bin tracks for damage. • Replace the output-bin-2 assembly. NOTE: The output-bin-2 assembly includes the outputbin- 2-shift motor (M38), outputbin- 2 area sensors, and the outputbin- 2 driver PCA. • Only if the error persists and none of the previous steps correct the problem, replace the stacker controller PCA.

← Xem tất cả mã lỗi HP Color LaserJet CM6049 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie