Code: 50.2X.YZ
Display: 50.2X.YZ Fuser Error
Description: The product experienced a fuser error. • X = fuser mode • Y = previous printer sleep state • Z = next printer sleep state
Low fuser temperature and fuser warm-up failure
Low fuser temperature and fuser warm-up failure
Remedy: 1. Remove the fuser, and then reinstall the fuser. Make sure that there is no residual paper in the fuser. Make sure that the product is not located in front of a vent or window where cool air may interfere with the ability of the fuser to heat up. 2. Check the product power source. Make sure that the power source meets product requirements. Make sure that this is the only device using the circuit. 3. Replace the fuser. 4. Check the connector (J50) between the fuser and the printer. If it is damaged, replace the fuser drive assembly or fuser. 5. If the error persists, replace the low-voltage power supply. 6. If this product has been previously serviced, check the connectors (J160 and J162) on the DC controller PCA and the connector (J25) on the power line between the low-voltage power supply assembly and the fuser.