Description: Connection problem with Heaters Control assembly. I2C Protocol not working. The firmware has detected that there is no communication to/from the Heaters Control Assembly and the Printmech PCA.
Remedy: • Check all the cables are connected between the Heaters Control assembly and the PrintMech PCA, try disconnecting and reconnecting them. • If there is no light on the 5v LED on the Heater Control PCA, (refer to ) this would indicate a lack of 5v to the Heaters Control assembly, check the cables from the PrintMech. • Replace the Heaters Control assembly (60 inch.). • Replace the PrintMech PCA .