Code: 14.10:00
Description: Open circuit on the Dryer Assembly. A certain amount of power is applied to the Dryer Assembly and is then the flow of current is measured, if the flow of current is not as expected, the system error is displayed
Remedy: • Check all the cables are connected in the Dryer Assembly, try disconnecting and reconnecting them. • Check the power connection to the Heaters control assembly PCA (J10). • Check the cable between the Dryer Input connection and the cable of the Dryer Residual Current Circuit Breaker (RCCD) • Disconnect the power input to the Dryer Assembly located at the rear of the printer, and reconnect. • Check to see if the Residual Current Circuit Breaker (RCCD) has blown, reset it, if it blows again immediately (or often), this would indicate an error with the Dryer Assembly or the RCCD. • Check to see if there is a blown fuse in the Heater Control Assembly (F1 and F2). • Replace the Heater Control Assembly . • Faulty resistor in the Dryer Assembly, replace the Dryer Assembly.