Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 14.08:00 — HP DesignJet L26500

Code: 14.08:00

Description: No AC voltage in the Dryer Assembly. The firmware has detected that there is no AC voltage in the Dryer Input connection.
Remedy: • Check that the power cables are correctly inserted at the rear of the printer. Check to see if a fuse has blown on one of the electrical input cables (when the region has a fuse in the power cord). • Check to see if the Residual Current Circuit Breaker (RCCD) has blown, reset it, if it blows again immediately (or often), this would indicate an error with the Dryer Assembly or the RCCD. • Check the electrical supply from the customer´s site. • Check that the power cables are correctly inserted at the rear of the printer. • Check to see if the Residual Current Circuit Breaker (RCCD) has blown, reset it, if it blows again immediately (or often), this would indicate an error with the Dryer Assembly or the RCCD. • Check the connections of the cables from the Dryer input connection, RCCD, the filter and the Heater Control Assembly. • Check to see if the fuses F1 and F2 have blown on the Heaters Control Assembly , if they have replace the Heater Control Assembly . • Check the 24 Volt LED on the PrintMech is on, see , check the connections between the Heaters Control assembly and the PrintMech PCA, try disconnecting and reconnecting them. • One of the following PCAs has failed and must be replaced: • Replace the Heater Control Assembly . • Replace the PrintMech . • Replace the Sausalito PCI PCA .

← Xem tất cả mã lỗi HP DesignJet L26500

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie