Description: Generic failure with the Heaters Control Assembly. There is a failure with the Heaters Control assembly.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check all the cables are connected in the Electronics module. • Replace the Heaters Control assembly (60 inch.). Note: If the Curing module has recently been replaced because of a faulty resistor, this fault can also damage the triac control system. • Replace the Sausalito PCI PCA . • Replace the PrintMech . • Replace the Main PCA Formatter . • Replace the internal cables of the Electronics Module.