Description: Problem with the Curing System Temperature Sensor. Signal error detected with the Curing System Temperature Sensor.
Remedy: • Check the Curing IR Sensor Fan is turning and is correctly installed with the fan in the correct orientation. • Check the cables are connected and not damaged. • Replace the Curing IR Sensor & Fan ËPage 510. • Replace the Printmech ËPage 482. • check if the Curing IR sensor is dirty and requires cleaning, use the cleaning procedures described in the Userfs Guide while observing all safety precautions while working in the area of the heaters. • Check the power going to the IR sensor. A good indication is that the blue LED on the sensorfs body will light if the sensor is pointing to an object warmer than 30c. • Perform the IR sensor diagnostic check g8.4 Curing IR sensorh ËPage 170, to check the values being detected by the IR sensor. Replace the Curing IR sensor if required ËPage 503.