Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 81:01 — HP DesignJet L28500

Code: 81:01

Description: Possible substrate jam
Causes: Media servo shutdown; possible substrate jam.
Remedy: 1. If the substrate is nearing the end of the roll, check that the remaining substrate is firmly attached to the core. 2. Open the Window, observing all safety precautions, and check for any visible obstacles restricting the movement of the Drive Roller. If there is a wrinkled mass of substrate inside the substrate path, lift the Pinchwheels (using the Media Lever) and clear the obstruction. 3. Check the performance of the Rewinder system as it may also cause a servo shutdown. 4. Check that the OMAS Controller Card to PrintMech PCA cable is not damaged. 5. Check that the OMAS Controller Card to PrintMech PCA cable is correctly connected to the OMAS Controller Card and the PrintMech PCA. 6. Perform the Drive Roller service test. 7. Check whether the 5 V LED (D55) on the PrintMech PCA is off; this could be caused by a short-circuit in the Curing IR Sensor Fan cable, usually due to being pinched by metallic parts. Check the cable; if it is damaged, replace it. 8. Replace the Media Axis Motor.

← Xem tất cả mã lỗi HP DesignJet L28500

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie