Remedy: 1. Switch the power off at the rear of the printer. 2. Disconnect all drying fans (not the array, the fans one by one). 3. Switch the printer on. 4. If the error persists, check that Secondary PSU cables are properly connected to PrintMech PCA and Main PSU. 5. If the error persists, replace the Extra 24 V PSU. 6. Connect the fans one by one until the error returns. Use the diagnostic test for the fans; it should switch them all on. 7. Replace the drying fan that caused the error. 8. Make sure that you test all of them: more than one may be faulty.