Causes: At least one of the switches of the waste management sub-assembly is in open status.
Remedy: 1. Check that the aerosol filter door is correctly closed (this can be done by the customer). 2. Check that the waste management ink tube is correctly inserted in the waste management subassembly (this can be done by the customer). 3. Replace the Waste Management module (this part can be changed by the customer). This is the most likely solution. 4. Check that the cable of the waste management system is correctly connected to the connector at the EBOX (this check can be done by the customer). 5. Check that the cable from the EBOX to the Interconnect PCA is correctly connected. 6. Check that the cables going from the Interconnect PCA to the PrintMech PCA are correctly connected. 7. Replace the Interconnect PCA. 8. Replace the PrintMech PCA.