Code: 13.B2.D3
Display: 13.B2.D3 Jam in top cover area (tray 3) (no optional input devices installed)
Description: Paper stay jam at top/registration sensor from Tray 3. This jam occurs when the paper does not reach the TOP sensor (SR9) within the designated amount of time from Tray 3.
Remedy: 1. Open the top cover, and then remove any jammed paper. IMPORTANT: Do not remove the toner cartridge. Make sure that you remove any jammed paper from the top cover area before proceeding to avoid tearing partially picked paper. Open Tray 3, remove any jammed paper, and then close Tray 3 and the top cover. 2. Check for obstructions in the paper path from Tray 3. 3. Check the pickup, feed, and separation rollers for Tray 3. Replace the rollers if they are worn or defective. 4. Make sure that the registration assembly shutter is properly functioning. Replace the registration assembly if necessary. 5. Use the Manual sensor tests to activate the pickup solenoid (listen for the solenoid to move) for Tray 3. If the solenoid is not properly functioning, replace the solenoid. 6. Use the Manual sensor tests to toggle the TOP sensor (SR9). If the sensor is not properly functioning, replace the high-voltage power supply. 7. Inspect the connector (J48) on the DC controller PCA, and connector (J63) on the Tray 3 lower clutch. 8. Use the Components tests to activate the drum motor (listen for the motor to rotate). If the motor is not properly functioning, replace the main drive assembly.