Description: Fuser Wrap Jam This jam occurs when the media disappears from the fuser output sensor (PS502) before a designated amount of time after the media reached the fuser output sensor (PS502). (It is determined that the media is being wrapped around the fuser roller) Z = Fuser mode • 13.B9.C1 Fuser wrap jam when Auto Sense (Normal). • 13.B9.C2 Fuser wrap jam when Normal. • 13.B9.C3 Fuser wrap jam when Light 1 or Light 2 (see event log secondary jam information for specific code). • 13.B9.C4 Fuser wrap jam when Heavy 1. • 13.B9.C5 Fuser wrap jam when Heavy 2. • 13.B9.C6 Fuser wrap jam when Heavy media 3. • 13.B9.C7 Fuser wrap jam when Glossy media 1. • 13.B9.C8 Fuser wrap jam when Glossy media 2. • 13.B9.C9 Fuser wrap jam when Glossy media 3. • 13.B9.CB Fuser wrap jam when Transparency. • 13.B9.CC Fuser wrap jam when Label. • 13.B9.CD Fuser wrap jam when Envelope 1 or Envelope 2 (see event log secondary jam information for specific code).
Remedy: 1. Open the left door. 2. Remove the fuser, and then remove any paper wrapped around the fuser roller. CAUTION: The fuser might be HOT. 3. Reinstall the fuser, and then close the door. 4. Print a cleaning page to make sure that all of the toner is removed from the fuser roller. 5. Use the manual sensor tests to toggle the fuser output sensor (PS502). If the sensor is not functioning correctly, replace the fuser assembly. 6. If the error persists, the fuser roller or pressure roller might be damaged. Replace the fuser.