Code: 13.B9.Bz
Display: 13.B9.Bz Fuser jam
Description: Multi-feed jam in fuser. This jam occurs when a near complete overlap (less than 5 to 15 mm of non-overlap) multi-feed jam is detected. • 13.B9.B1 Multi-Feed jam is detected when printing from Tray 1. • 13.B9.B2 Multi-Feed jam is detected when printing from Tray 2. • 13.B9.B3 Multi-Feed jam is detected when printing from Tray 3. • 13.B9.B4 Multi-Feed jam is detected when printing from Tray 4. • 13.B9.BD Multi-Feed jam is detected when printing from the Duplexer.
Remedy: 1. Open the Right door and clear the jam in the indicated area. 2. Close the door to allow the printer to attempt to clear the jam. 3. Ensure sure that the paper meets HP printer specifications and is loaded in the trays correctly. 4. Make sure that the tray width and length guides are set to the correct paper size being installed into the tray and that the tray is not over filled above fill mark and over the tab on the tray. 5. Make sure that the pickup, feed, and separation roller for the specified tray are installed correctly and show no damage or wear. 6. Clean or replace the pickup/feed rollers as needed.7. Check Fuser delivery sensor for proper functionality and movement.8. Verify there is no debris from a previous jam stuck in the fuser or rollers leading into or out of the fuser.9. Confirm the output bin rollers are turning.10. Perform Manuel Sensor Test and check SR9 Fuser delivery sensor and PS1 fuser loop sensor. If found faulty then replace the Fuser assembly.11. Perform Manuel Sensor Test and Replace the fuser assembly.