Code: 50.WX.YZ
Display: 50.WX.YZ
Description: The fuser has experienced an error. W = fuser error code, X = fuser mode, Y = previous printer sleep state, and Z = next printer sleep state. Fuser modes and sleep states are listed after all 50.WX.YZ troubleshooting. The specific issues are: • 50.1X: Low fuser temperature • 50.2X: Fuser warm up service • 50.3X: High fuser temperature • 50.4X: Drive circuit fault • 50.6X: Open fuser circuit (heating element failure) • 50.7X: Depressurizing mechanism malfunction • 50.8X: Low fuser temperature 2 • 50.9X: High fuser temperature 2 • 50.AX: Low fuser temperature 3 • 50.BX: High fuser temperature 3
Remedy: action1. Turn the printer off, and then on.2. If the error returns, turn the printer off and ensure the printer is directly plugged into a wall outlet (remove any surge protector or UPS).3. If the error persists, try a different wall outlet (if possible), one that is preferably on a dedicated or different circuit.4. Make sure that the correct fuser model is installed in the printer and that it meets the appropriate voltage requirements.5. Make sure the fuser is seated properly.6. If the error persists, continue troubleshooting based on the individual error listed below. Fuser Modes: 0 = Photo Media 1, 2, 3 1 = Normal-Auto Sense 2 = Normal 3 = Light 1 4 = Heavy 1 5 = Heavy 2 6 = Heavy 3 7 = Glossy 1 8 = Glossy 2 9 = Glossy 3 A = Glossy Film B = Transparency C = Label D = Envelope 1 E = Rough RoughPrinter State / Sleep States 0 = Printing 1 = Standby level 1 (no temperature control) 2 = Standby level 2 (high temperature control) 3 = Standby level 3 (middle temperature control) 4 = Standby level 2 (low temperature control) 5 = Middle sleep 6 = Deep sleep F = Power off