Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 59.00.C0 — HP LaserJet M575 Enterprise 500 Color MFP

Code: 59.00.C0

Display: 59.00.C0
Description: Developing disengagement motor (M10) error
Remedy: 1. Open the following menus: • Administration • Troubleshooting • Diagnostic Tests • Component Test Use the Alienation Motor test to verify that the disengagement mechanisms are properly functioning. If they are not, replace the developing disengagement motor. 2. Check the following connectors: • On the developing disengagement motor (M10): Connector J25 • On the high-voltage power supply PCA: Connectors J261 and J251 • On the DC controller PCA: Connectors J138 and J106 3. Use the Manual Sensor Test to verify that the developer disengagement sensor (SR11) is properly functioning. The sensor is located inside the main drive assembly and cannot be reached for testing. Disconnect the connector (J112) at the DC controller while in Manual Sensor Test mode to verify the sensor operation. If it is not operating, replace the main drive assembly. NOTE: The normal state is 0. Locate the in-line connector (J70) in the cable that is connected to developing-home-position sensor (SR11). To find this connector, remove the left-side cover and look in the area below the support plate. Disconnect the in-line connector. The state of sensor (SR11) should change to 1. 4. If the motor is defective, replace the motor (M10). If the sensor is defective, replace the main-drive assembly (RK2-2415-000CN; development disengagement stepping motor M10). 5. If the error persists, elevate the problem to your Global Business unit.

← Xem tất cả mã lỗi HP LaserJet M575 Enterprise 500 Color MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie