Code: 60.00.03
Display: 60.00.03 Tray 3 lifting error
Description: Tray 3 lifting error. Tray 3 did not raise to the paper surface sensor in the required amount of time.
Remedy: 1. Remove the tray and manually rotate the gear on the rear of the tray to make sure that the lift mechanism is working. 2. With the tray removed, pressing any of the paper size switches will cause the tray lift motor to run. If the motor does not work, replace the lifter assembly. 3. Use the Tray/Bin manual sensor test to verify that the Tray 3 paper (SR1 and SR2) surface sensors are properly functioning. 4. If this part has been removed or replace, check the connector (1606 and 1607) on the on the paper feeder controller PCA. 5. If the error persists, replace the lifter drive assembly (Tray 3).