Code: 13.A1.D1
Display: 13.A1.D1 Jam in Tray 1
Description: Paper Delay Jam in Tray 1. This jam occurs when the paper does not reach the TOP sensor (Registration sensor) (PS-103) in designated amount of time after the start of paper pick-up from Tray 1. This is a no-pick jam from tray 1 (MP Tray).
Remedy: 1. Clear the jam in the area indicated. 2. Make sure that the MP tray paper guides are set to the correct paper size in the tray, and that the paper is not overload above the marking shown on the tray side guide 3. Check the Tray 1 pickup and feed rollers for wear, damage or paper dusk. Clean or replace the rollers as needed. 4. Perform a test print job, do the rollers turn and feed paper when the product tries to print from Tray 1? • IF YES: Test the feed sensor using the sensor test under the- Administration - Troubleshooting - Diagnostic Tests menu to verify that the sensor is functioning properly. • IF NO: Run the Tray 1 pickup/feed motor drive test under the . Administration - Troubleshooting - Diagnostic Tests- menu to verify that the feed motor is functioning properly. If the test fails or if there is an abnormal noise replace the MP (Tray 1) pickup assembly.