Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 13.B2.Az — HP LaserJet M630h Enterprise MFP

Code: 13.B2.Az

Display: 13.B2.Az Paper Jam
Description: Paper stopped at the registration jam, from the tray indicated. This jam occurs when the paper is present longer than "the expected paper length plus 50mm or more?h when detected at the registration sensor PS103. • 13.B2.A1 = Tray 1 • 13.B2.A2 = Tray 2 • 13.B2.A3 = Tray 3 • 13.B2.A4 = Tray 4 • 13.B2.A5 = Tray 5 • 13.B2.AD = Duplexert
Remedy: 1. Open the top cover and clear the jam in the indicated area. Inspect the paper path and make sure that no paper is blocking the paper path. 2. Make sure that the tray width and length guides are set to the correct paper size being installed into the tray and that the tray is not over filled above fill mark on tray. 3. Test TOP sensor/Registration Sensor (PS103) using the manual sensor test under the following: Administration Troubleshooting Diagnostic Test Manual Sensor Test elevate the case following your standard support process. 4. If the sensor is functioning properly, run a few pages to check where the leading edge of the paper actually stops. 5. Check the area where the leading edge of the paper has stopped for blockage or damage. Remove any obstructions that are found.

← Xem tất cả mã lỗi HP LaserJet M630h Enterprise MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie