Code: 13.A3.FF
Display: 13.A3.FF Paper Jam
Description: Residual paper jam in Tray 3. This jam occurs when residual paper is detected at the Tray 3 feed sensor (SR4) at power on.
Remedy: 1. Open the tray, and right door and remove any jammed paper, and then close the tray. 2. Open and close any door on the product to allow the product to attempt to clear the jam. 3. Make sure that the tray width and length guides are set to the correct paper size being installed into the tray and that the tray is not over filled above fill mark on tray. 4. Verify that the Tray 3 pickup, feed, and separation rollers are correctly installed and that they are not worn or damaged. Clean or replace the rollers as needed. 5. Use the manual sensor tests to toggle SR4. If the sensor is not functioning properly, replace the Tray 3 Pick up Assembly. 6. Check the following connectors for Tray 3 on the HCI controller and assembly. (J13, J408 Media feed sensor) (J18, J408 Pick up assembly (J14, J409 Pick up motor) 7. If the error persists, replace the Tray 3 paper pickup assembly.