Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 50.2X.YZ — HP LaserJet M750dn Color Enterprise

Code: 50.2X.YZ

Display: 50.WX.YZ Fuser error To continue turn off then on
Description: Low fuser temperature and fuser warm-up failure
The fuser has experienced an error. W = fuser error code, X = fuser mode, Y = previous printer sleep state, Z = next printer sleep state
Fuser modes: • Normal.Auto Sense • Normal • Light 1 • Heavy 1 • Heavy 2 • Heavy 3 • Glossy 1 • Glossy 2 • Glossy 3 • Glossy Film • Transparency • Label • Envelope 1 • Rough
Sleep states: • Standby level 1 (no temperature control) • Standby level 2 (high temperature control) • Standby level 3 (middle temperature control) • Standby level 2 (low temperature control) • Middle sleep • Deep sleep • Power off
Remedy: 1. Remove and then reseat the fuser. Make sure there is no residual paper in the fuser. Make sure the device is not located in front of a vent or window where cool air may interfere with the ability of the fuser to heat up. 2. Check the product power source. Make sure the power source meets product requirements. Make sure this is the only device using the circuit. 3. Replace the fuser. 4. Check the connector (J704) between the fuser and the printer. If it is damaged, replace the fuser drive assembly or fuser. 5. If the error persists, replace the low-voltage power supply. 6. If this product has been previously serviced, check the connector (J131) on the DC controller PCA and the connectors (J109 and J110) on the power line between the low-voltage power supply assembly and the fuser.

← Xem tất cả mã lỗi HP LaserJet M750dn Color Enterprise

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie