Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 50.7X.YZ — HP LaserJet M775z plus Enterprise 700 color MFP

Code: 50.7X.YZ

Display: 50.WX.YZ Fuser error To continue turn off then on
Description: Fuser pressure-release mechanism failure
The fuser has experienced an error. W = fuser error code, X = fuser mode, Y = previous printer sleep state, Z = next printer sleep state
Fuser modes: • Normal.Auto Sense • Normal • Light 1 • Heavy 1 • Heavy 2 • Heavy 3 • Glossy 1 • Glossy 2 • Glossy 3 • Glossy Film • Transparency • Label • Envelope 1 • Rough
Sleep states: • Standby level 1 (no temperature control) • Standby level 2 (high temperature control) • Standby level 3 (middle temperature control) • Standby level 2 (low temperature control) • Middle sleep • Deep sleep • Power off
Remedy: 1. Remove and then reseat the fuser. Make sure there is no residual paper in the fuser. 2. Check the fuser pressure-release sensor flag. If it is damaged, replace the fuser. 3. Use the sensor test in the Manual sensor test to verify that the fuser pressure-release sensor (PS9) is properly functioning. If it is not, replace the fuser gear assembly. 4. Use the fuser pressure-release drive test in the component test to verify that the fuser motor (M4) is properly functioning. If it is not, replace the fuser motor. 5. If the error persists, replace the low-voltage power supply. 6. If this product has been previously serviced, check the connector (J181) on the DC controller PCA.

← Xem tất cả mã lỗi HP LaserJet M775z plus Enterprise 700 color MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie