Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 16.01.01:05, 16.01.02:05 — HP Latex 3000

Code: 16.01.01:05, 16.01.02:05

Description: Curing module X warm-up timeout module disabled, substrate going under this module won't be cured. But if module is required to print, run subsystem diagnostic. If problem persists, call support.
Causes: a. Curing module cannot reach target temperature on time. b. Curing bar is not properly closed and latched. c. Curing module is not closed or has an internal failure (fan or resistor).
Remedy: 1. Check that the module is properly closed and sealed. 2. Run subsystem diagnostics. 3. Replace fan/resistor module.

← Xem tất cả mã lỗi HP Latex 3000

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie