Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 22.11.01:01, 22.11.02:01 — HP Latex 3000

Code: 22.11.01:01, 22.11.02:01

Description: APS open relief valve error 0X. Run IDS diagnostic. If the problem persists, call your support representative.
Causes: a. The system is considered to be depressurized at 0.3 psi, and there is a timeout of 120 seconds to depressurize. b. The standard operating range is 5.2–5.6 psi (working pressure). c. Block flow pressure 3.6–4 psi (not printing but refilling, the selected side is pressurized to this level to ensure that refilling is done on the expected side), while printing the unused side is pressurized to prevent backwards refilling.
Remedy: 1. Check that the relief valve cable is correctly connected to the valve and to the ISS Main Board. 2. Open and close the relief valve several times to check that it works (this can be done with a finger). 3. Swap the relief valve connections to check whether the failure is the driver or the relief valve. If the cause is the valve, remove and replace it. 4. If the failure is the actual driver of the electrovalve, replace the ISS main board. 5. Disconnect the tubes and perform a visual inspection of the system, in case of doubt disconnect the tube and blow into it to ensure that there is no blockage towards the relief valve. 6. If the relief system seems to be working correctly, replace the ISS main board. 7. Replace the air pump, relief valve, and tubes

← Xem tất cả mã lỗi HP Latex 3000

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie