Mã lỗi 52.01.01:01 ... 52.01.07:01 — HP Latex 3000
Code:
52.01.01:01 ... 52.01.07:01
Description: Drop-detector sensor 0X issue detected, sensor disabled. Run subsystem diagnostic. Call your support representative if diagnostic fails, or print quality is affected. The drop detectors’ basic operation consists of receiving power to feed an LED transmitter and a receiver situated at both sides of the drop-detector window. In standby with no drops or interference in the drop detector window, the transmitter is permanently powered and the receiver receives a signal of medium range (total range from 0 to 255, medium range signal around 127). The system error is displayed when the drop detector is 0 in standby (12 V supplied to the drop detectors, but there is no drop detection activity).
Causes: a. Drop detector disconnected b. Drop detector failed c. Service station interconnect board or cable failed d. Main interconnect board failed
Remedy: 1. Make sure that the drop detector is correctly connected to the service station interconnect board. Use diagnostics to check whether the drop detector is disconnected or faulty. 2. Swap the problematical drop detector connection with another drop detector to check whether the problem is with the actual drop detector. If so, replace the drop detector. 3. Check the service station interconnect board cable connections at both ends. Make sure the cable is well connected and check cable integrity, replace parts if required. 4. Ensure power (12 V and 5 V) arrives to the board (Power LEDs on). Check the LEDs in the drop detector interconnect. 5. Replace service station interconnect board and cable. 6. Replace the OMAS PCA.