Code: 32:01.1
Description: TUR early media jam
Causes: This system error happens when there is a small amount of substrate printed (less than 79 inches long), and the Take Up Reel sensor detects that the tension bar is (incorrectly) at the bottom of its path, even though the spindle motor has been rotating for more than 3 seconds. The most likely cause of this error is that the user has forgotten to set the switch direction or tape the substrate to the spindle core.
Remedy: 1. Check that the substrate is attached to the Take-Up Reel. 2. Check that the winding direction switch is in the correct position. 3. If needed, use the Take-Up Reel arrow keys to wind the substrate before resuming printing. 4. To resume printing, press OK.