Mã lỗi 54.30.00 — HP PageWide Enterprise Color MFP 586
Code:
54.30.00
Description: Calibration error An engine calibration has failed. Details of which calibration and failure reason can be found in the payload. 610000AC Sensor_Cms_Calibrate_Unknown_Sensor Tried to start a page calibration scan with an unknown sensor ID. Only Zim and BDD sensors are recognized. 610000AD Sensor_Cms_Calibrate_Invalid_Sensor A sensor other than Zim was specified for the pen calibration scan. 610000AE Sensor_Cms_Calibrate_Overshoot The paper advanced too far during a page calibration such that the printed artifact could not be scanned. This assert could happen if the mech wasn't able to stop the paper movement accurately.
Remedy: 1. Turn the power off on the product by pressing the power button and holding it for more than 3 seconds. 2. Unplug power cord from back of product and wait 30 seconds. 3. Plug power cord back into product. 4. Turn the power on to the product using power button. 5. If the error condition is cleared then the issue is resolved, if not continue to step 6. 6. Repeat steps 1 & 2. 7. Remove the formatter, check formatter thoroughly for any loose connections and reseat them, then reinstall the formatter. 8. Repeat steps 3 & 4. 9. If the error condition is cleared then the issue is resolved, if issue is not resolved replace the Mech Kit. NOTE: It is critical to either print the event log after power cycle clears issue, or access the event log through EWS and capture the 8 character fail code value corresponding to the 61.00.0X and log it into the case. Look for the last 61.00.0x error that occurred which also has the 8 character value under the text . This value is critical in HP understanding the failure and debugging potential field issues.